Used 1991 Ford Mustang LX 5.0 Coupe for Sale - Stock #3991398

1988 Ford Mustang LX Hatchback for Sale in Everett, WA 98203 This 1988 Ford Mustang is Powered by a 5.0L V8 Engine Paired with a 5 Speed Manual Transmission Producing 400HP and only 50,000 Miles on the Motor. This Mustang is Nardo Grey with Black and; Grey Interior. Never Driven in the Rain, has been Garage Kept and Owners are Non-Smokers. This Ford Mustang is Built on a 1991 Chassis and is Titled as a 1991. Features Tremec Housing T5 Tranny Built by Ford Performance for 800hp Fox Body with All the Comforts You Would Want for A Road Trip Plush Quiet Ride Delivered Through the Eibach Suspension Insulation Behind All the Factory Interior Panels Amazing Stereo Capable of Any Music at Any Level Power Windows and Mirrors Power Locks Navigation A/C Cruise Control Power Mirrors Looks Like the 10 Point Roll Cage Was Molded into The Interior Seats That Give Every Bit of Comfort and Support for The Car Secure 4 Point Harnesses That Are Easy and Quick to Get in and out of With One Connection with A Conventional Lap Buckle MOTOR: -GT 40 Heads Directional ported intake ports and polished exhaust ports (everything is gasket and port matched) and all top end is held down with ARP fasteners - trick flow 1.6 roller rockers - Ford performance push rods and hydraulic roller lifters- Ford performance E 303 cam - tubular intake ported and polished - 26lb accel fuel injectors- BBK MAF programmed to 26lb injectors - BBK 70mm throttle body - BBK adjustable fuel pressure regulator - BBK under drive pulley set up - MSD billet pro distributor - BBK equal length shorty headers into a full stainless 2.5” H pipe duel exhaust. - flow master 44s TRANSMISSION/ REAR END:Ford Performance T5 transmission with short shifter - Ford performance aluminum drive line - 3.73 Yukon gears and limited slip with reinforced housing. - Yukon 31 spline axles BRAKES/ CHASSIS:-Willwood full floating rotors and spindles, 4 piston calipers on all 4 wheels - 10 point roll cage with all points plated with 3/16” 7x7” and connected to chassis with weld in floor sub frame connectors and gussets to essentially create a full frame -Front and Rear shock tower bracing-BBK lower control Arms - BMR adjustable upper control arms - Bushingless insert for upper control arm connection to the rear end Sellers Note: “The Car Is a True 55,000 Mile Car with So Many Goodies I Do not Have the Space to List. It Currently Is Producing a Very Reliable and Fun 400 Hp. But Is Set Up from The Trans Back (And Chassis) To Reliably Take 800hp. There Is So Much Special to Say About This Car and If You Are Interested Come See for Yourself This Is Truly a One-off a Kind and Very Special Car” For assistance with Financing, Transportation, or Inspections please e-mail or phone Customer Support at (402) 502-8385 ATTENTION BUYERS*Caveat Emptor* Please Remember to Inspect Vehicle Prior To Purchase!